Categories

False alarms and system malfunctions can be exasperating, and more importantly, could prevent your home’s security from working the way it should. Fortunately, most problems, from false alarms to dead batteries, are simple to fix. Take a look at our suggestions for troubleshooting your home alarm system in Colorado Springs. We’ll help keep your family members shielded and your system operating as it should.

Test Your Home Security System In Colorado Springs

One sensible way to troubleshoot your property’s security is to test it! Modern systems let you put them in test mode to prevent you from initiating an emergency response. Once in test mode, follow these steps:

• Turn on your system as you typically would when heading out.
• Open a door or window that uses a contact sensor, or test other equipment. Close the door or window once you’re finished so it doesn’t trigger the alarm as you get out of test mode.
• Allow the alarm to resonate for 60 seconds to make sure a signal is delivered to the security company and an entry is created in the alarm system log.
• Proceed to test equipment as needed
• Review the systems’s activity log to confirm functionality.

Don’t worry, monitoring specialists can tell that your alarm system is involved in a test. Be sure to switch off test mode when you’re done. It’s a good idea to test once a month or whenever you change your home’s phone or internet provider.

Check The Placement And Condition Of Motion Detectors

Although an essential aspect of your alarm system, motion detectors are prone to false alarms. Prevent them with a few straightforward troubleshooting steps.

• Do a physical inspection. Is there anything that could shift within the detection path of the sensor, like drapery taken by a breeze?
• Is the sensor dirty? Grime, dirt, and cobwebs can cause issues. Make sure the sensor is clean.
• Does the motion detector come with pet immunity you can activate? Some can be configured to disregard pets weighing up to 100 pounds.
• When was the battery replaced? Low batteries might impact performance or result in false alarms.
• Is a heat source affecting the sensor? Too much heat from a fireplace, direct sun, or something else can cause an alarm.

Keep Batteries Ready And Look Out For Low Battery Signals

One of the great advantages of new home security systems is that they’ll alert you when batteries are getting low. If your system has a app or control panel, you’ll usually see notifications there. Depending on your system, you could detect an intermittent beep when batteries are getting low. 

Motion detectors, smoke detectors, contact sensors, and other wireless components have batteries that will have to be replaced every year or two. It’s a good idea to keep batteries around and establish a replacement schedule. Top systems also have a backup battery for the primary control panel. This backup battery keeps your system functioning if you have a power outage and should recharge itself once power is back online. If it fails to recharge, you should replace it.

Troubleshooting Is Easy With ADT Home Security In Colorado Springs 

As the leading name in home security, ADT creates systems that offer superior protection and functionality. Accessing test mode is easy through the ADT+ app or MyADT.com, and you’ll always be sent notifications when a sensor battery is nearing depletion. Contact Secure24 Alarm Systems, an authorized ADT dealer, to find out more and design a system perfectly suited to your Colorado Springs home and family. Dial (719) 270-0648 or complete our form today!