A nice benefit of getting your security system installed by professionals is that you hardly ever find a reason to worry about it. Even so, there will likely be a couple situations where you need to reset your alarms in Colorado Springs. If you’re utilizing a smart command interface, your system reset normally takes a few minor taps of the touchscreen when you’ve experienced a false alarm, power outage, or battery change.
Read The Instruction Manual Before Trying to Reset Your Alarm Panel
A word to the wise before you try to reset your Colorado Springs home security system, read your owner’s manual ahead of time. You wouldn’t want to undermine your system because you hit something incorrectly. Also, the process may be different if you switched from a numerical keypad to a digital command hub. If there’s ever a time when you’re struggling to reset your system, don't hesitate to call your trusted security specialists.
Resetting Your Colorado Springs Home Security System After A False Alarm
Generally, a false alarm takes place due to an accidentally tripped sensor. You are able to engage the ADT Command touchscreen or open your ADT security app and tap the shield image and submit your security code to deactivate the alarms in these situations. You may get a call from your 24-hour monitoring specialists, but just let them know it was a false alarm.
How To Reset Your Alarm Following A Power Outage In Colorado Springs
If the power goes out from a storm or other event, you might start hearing a beeping sound from your central command hub. That indicates that your home’s defense is running off the secondary power source. To reset the alarm and halt the beeping, you must take steps to disarm and rearm your security.
Keep in mind, if power is out for an extended time, you may need a total reset of your home’s security. Heed the directions in the manual -- normally by submitting your PIN number and tapping the designated button two times -- and you should be back to normal. You might keep hearing chirps from the backup power, as it may not end until your battery reaches a full charge. Call your security technician if you keep having difficulties with your ADT system at least 20 hours after the power is resumed.
When You Need To Reset Your Home Security System After Replacing A Battery
There will be infrequent times when you must switch out a battery powering one of the devices in your security installation. To do this, you will set your alarm system to test mode so you prevent setting off an alarm by accident. When the you replace the old battery, change the alarm from Test Mode and resume normal operations. If the command center doesn't recognize the device or the battery light stays on, you could need a full reset of your security system.
Resetting Your Colorado Springs Security System When Adding Or Removing A Code
Removing or adding personal codes can be done on your ADT Command interface and your ADT mobile app. You won’t need a resetting of your system when deleting or adding a user or code. With that being said, if you relocate to a new property already equipped with an ADT system, you need to contact your home security professional at (719) 270-0648 to set up a new contract. The technician will visit your property to switch out components, place other alarms or cameras (if needed), and perform a full reset.
A User-Friendly Security System Is Only A Call Away
Resetting a home security system in Colorado Springs can be frustrating if it isn’t equipped with user-friendly instructions and features. If you’re ready to get your functional and powerful alarm system, dial (719) 270-0648 or submit the form below. Our team is ready to design the right security system for your needs.